NDSS Academy
You can keep up to 10 CVs here -- delete one you don't need.
You can keep up to 10 CVs here -- delete one you don't need.
You can keep up to 10 CVs here -- delete one you don't need.

Microcontroller Lab (Diploma)

8051 programming and interfacing experiments.

6 MonthsDuration 5Chapters21Topics
Enquire now

Syllabus · पाठ्यक्रम

Download PDF
01Introduction to 8051 Trainer Kit and Keil IDE 3 topics
  1. Study of 8051 trainer kit
  2. Keil IDE: project, build and debug
  3. Downloading the hex file
02Assembly Language Programs 5 topics
  1. 8-bit addition and subtraction
  2. Multiplication and division
  3. Block transfer
  4. Largest / smallest number in an array
  5. BCD to ASCII conversion
03Timer, Serial and Interrupt Programs 4 topics
  1. Delay using Timer 0 mode 1
  2. Square wave generation
  3. Serial transmission at 9600 baud
  4. External interrupt program
04Interfacing Experiments 6 topics
  1. LED blinking and running lights
  2. 7-segment display
  3. 16x2 LCD
  4. 4x4 keypad
  5. ADC0804
  6. Stepper motor and DC motor control
05Mini Applications 3 topics
  1. Traffic light controller
  2. Temperature display using LM35
  3. Relay based appliance control

About

You will be able to

  • Enter, assemble and run programs on an 8051 trainer kit and Keil IDE
  • Write arithmetic, logical and data transfer programs in 8051 assembly
  • Generate delays using timers and send data through the serial port
  • Interface LEDs, 7-segment display, LCD, keypad, ADC and stepper motor
  • Build a small application such as a traffic light or temperature display

Who it is for

  • Diploma Electrical Engineering students of Semester 5 (BTEUP)
  • Polytechnic students of other boards studying the same subject who want unit-wise coaching

What you need

  • Microcontroller and Applications theory of the same semester
  • Basic C programming

Questions

Which syllabus does the Microcontroller Lab course follow?

It follows the BTEUP (Board of Technical Education, Uttar Pradesh) diploma syllabus for Microcontroller Lab (Electrical Engineering, Semester 5). If your own board's or institute's syllabus differs, the centre follows your own syllabus.

Will this help in the practical examination and viva?

Yes. Every experiment is practised with the aim, circuit, procedure, observation table and result, followed by viva questions as asked in the BTEUP practical exam.

Which software is used?

Keil uVision for assembly / embedded C with a simulator, and an 8051 trainer kit or development board for hardware.

Download the syllabus (PDF)

Tell us who you are — your copy is made with your name, and our counsellor can help you choose the right course and centre.

Want to join right away? Enquire now — our centre will call you.