Microcontroller Lab (Diploma)

8051 programming and interfacing experiments.

6 महीनेअवधि 5Chapters21टॉपिक

अभी पूछताछ करें

सिलेबस · पाठ्यक्रम

Download PDF

01Introduction to 8051 Trainer Kit and Keil IDE 3 टॉपिक

Study of 8051 trainer kit
Keil IDE: project, build and debug
Downloading the hex file

02Assembly Language Programs 5 टॉपिक

8-bit addition and subtraction
Multiplication and division
Block transfer
Largest / smallest number in an array
BCD to ASCII conversion

03Timer, Serial and Interrupt Programs 4 टॉपिक

Delay using Timer 0 mode 1
Square wave generation
Serial transmission at 9600 baud
External interrupt program

04Interfacing Experiments 6 टॉपिक

LED blinking and running lights
7-segment display
16x2 LCD
4x4 keypad
ADC0804
Stepper motor and DC motor control

05Mini Applications 3 टॉपिक

Traffic light controller
Temperature display using LM35
Relay based appliance control

परिचय

आप यह कर पाएँगे

Enter, assemble and run programs on an 8051 trainer kit and Keil IDE
Write arithmetic, logical and data transfer programs in 8051 assembly
Generate delays using timers and send data through the serial port
Interface LEDs, 7-segment display, LCD, keypad, ADC and stepper motor
Build a small application such as a traffic light or temperature display

यह किसके लिए है

Diploma Electrical Engineering students of Semester 5 (BTEUP)
Polytechnic students of other boards studying the same subject who want unit-wise coaching

आपको क्या चाहिए

Microcontroller and Applications theory of the same semester
Basic C programming

सवाल

Which syllabus does the Microcontroller Lab course follow?

It follows the BTEUP (Board of Technical Education, Uttar Pradesh) diploma syllabus for Microcontroller Lab (Electrical Engineering, Semester 5). If your own board's or institute's syllabus differs, the centre follows your own syllabus.

Will this help in the practical examination and viva?

Yes. Every experiment is practised with the aim, circuit, procedure, observation table and result, followed by viva questions as asked in the BTEUP practical exam.

Which software is used?

Keil uVision for assembly / embedded C with a simulator, and an 8051 trainer kit or development board for hardware.