Design of Concrete Structures (B.Tech)

Limit state design of RCC beams, slabs, columns and footings as per IS 456.

6 महीनेअवधि 5Chapters25टॉपिक

अभी पूछताछ करें

सिलेबस · पाठ्यक्रम

Download PDF

01Unit 1: Design Philosophies and Limit State Method 5 टॉपिक

Working stress, ultimate load and limit state methods
Characteristic loads and strengths
Partial safety factors
Stress-strain curves and stress block parameters
Limit states of collapse and serviceability

02Unit 2: Design of Beams for Flexure 5 टॉपिक

Singly reinforced rectangular beams
Balanced, under- and over-reinforced sections
Limiting moment of resistance
Doubly reinforced beams
Flanged (T and L) beams

03Unit 3: Shear, Bond, Torsion and Serviceability 5 टॉपिक

Nominal and design shear stress
Design of shear reinforcement
Bond and development length
Design for torsion
Deflection control and cracking

04Unit 4: Design of Slabs and Stairs 5 टॉपिक

One-way slabs
Two-way slabs (IS 456 coefficients)
Continuous slabs
Cantilever slabs
Staircases

05Unit 5: Columns and Footings 5 टॉपिक

Short and slender columns, effective length
Axially loaded short columns
Uniaxial and biaxial bending (SP 16 charts)
Isolated square and rectangular footings
Detailing as per IS 456 and SP 34

परिचय

आप यह कर पाएँगे

Explain working stress and limit state design philosophies and IS 456 provisions
Design singly reinforced, doubly reinforced and flanged beams for flexure
Design for shear, bond, development length and torsion; check deflection and cracking
Design one-way and two-way slabs and staircases
Design short and slender columns under axial load and bending
Design isolated footings and prepare reinforcement details

यह किसके लिए है

B.Tech Civil Engineering students of Semester 6 (AKTU)
Students of other universities studying the same subject who want unit-wise coaching

आपको क्या चाहिए

Structural Analysis and Solid Mechanics
IS 456:2000 and SP 16 (provided in class)

सवाल

Which syllabus does the Design of Concrete Structures course follow?

It follows the AKTU (Dr. A.P.J. Abdul Kalam Technical University, Lucknow) B.Tech syllabus for Design of Concrete Structures. If your own university's syllabus differs, the centre follows your university syllabus.

Will this help in the university examination?

Yes. Teaching is unit-wise as per the AKTU scheme, with previous-year question practice, MCQ tests and doubt sessions before the semester exam.

Is SP 16 and detailing taught?

Yes. Design is done with IS 456 and SP 16 charts, and each design ends with a reinforcement detail sketch as expected in AKTU exams.