CNC Lab (Diploma)

Writing and running part programs on CNC lathe and milling machines.

6 महीनेअवधि 5Chapters17टॉपिक

अभी पूछताछ करें

सिलेबस · पाठ्यक्रम

Download PDF

01CNC Machine Familiarisation and Safety 3 टॉपिक

Control panel and modes (EDIT, MDI, JOG, AUTO)
Reference point return
Safety rules for CNC

02Work and Tool Setting 3 टॉपिक

Work offset G54
Tool length / geometry offsets
Wear offsets for size correction

03CNC Turning Programs 4 टॉपिक

Facing and step turning
Taper and radius turning
Stock removal cycle G71
Grooving and thread cutting cycles

04CNC Milling Programs 4 टॉपिक

Contour milling with cutter compensation
Pocket milling
Drilling cycles G81 and G83
Subprograms

05Simulation and Verification 3 टॉपिक

Simulation software
Dry run and single block
Inspection of the machined part

परिचय

आप यह कर पाएँगे

Operate a CNC lathe and machining centre safely in all modes
Set work offsets and tool offsets
Write, simulate and run turning programs with step, taper, radius and threading
Write and run milling programs for contours, pockets and drilling cycles
Verify programs with simulation, dry run and single block mode

यह किसके लिए है

Diploma Mechanical Engineering students of Semester 5 (BTEUP)
Diploma Production students and ITI Machinist pass-outs

आपको क्या चाहिए

Theory of CNC Machines and Automation (G and M codes)

सवाल

Will I run programs on a real machine?

Yes. After simulation, each program is run on the CNC trainer lathe / mill under supervision.

Which control system is used?

Fanuc-style ISO codes; other controllers available at the centre are also shown.

Is this course based on the BTEUP syllabus?

Yes. The units follow the BTEUP (Board of Technical Education, Uttar Pradesh) diploma syllabus. If your polytechnic follows a different board or a revised scheme, the centre teaches your own syllabus.