Embedded Systems Lab (Diploma)

Embedded C programming and interfacing with microcontroller boards.

6 महीनेअवधि 5Chapters18टॉपिक

अभी पूछताछ करें

सिलेबस · पाठ्यक्रम

Download PDF

01Development Tools and Board Setup 3 टॉपिक

Keil uVision and Arduino IDE
Board setup and flashing
Simulation and debugging

02GPIO Programs 3 टॉपिक

LED blinking and patterns
Switch input with pull-up
Buzzer and relay control

03Display and Input Interfacing 3 टॉपिक

7-segment display
16x2 LCD
4x4 keypad

04Timers, Interrupts and Serial Communication 4 टॉपिक

Timer delay
External interrupt
PWM generation
UART communication with PC

05Sensor and Motor Interfacing 5 टॉपिक

Temperature sensor using ADC
DC motor speed control using PWM
Stepper motor कंट्रोल
I2C RTC module
Simple IoT data upload

परिचय

आप यह कर पाएँगे

Set up Keil / Arduino IDE, compile programs and flash a microcontroller board
Write embedded C programs for LEDs, switches, buzzer and relay
Interface 7-segment display, LCD and keypad
Use timers, interrupts, PWM and UART
Interface temperature sensors, DC and stepper motors and an RTC

यह किसके लिए है

Diploma Electronics Engineering students of Semester 5 (BTEUP)
Polytechnic students of other boards studying the same subject who want unit-wise coaching

आपको क्या चाहिए

Microcontroller and Embedded Systems theory of the same semester
Basic C programming

सवाल

Which syllabus does the Embedded Systems Lab course follow?

It follows the BTEUP (Board of Technical Education, Uttar Pradesh) diploma syllabus for Embedded Systems Lab (Electronics Engineering, Semester 5). If your own board's or institute's syllabus differs, the centre follows your own syllabus.

Will this help in the practical examination and viva?

Yes. Every experiment is practised with the aim, circuit, procedure, observation table and result, followed by viva questions as asked in the BTEUP practical exam.

Which boards are used?

8051 kits, Arduino Uno and, where available, STM32 / ARM boards with sensors and display modules.