Electronic Devices and Circuits (Diploma)

Diodes, transistors, FETs, rectifiers, amplifiers, oscillators and regulated power supplies.

6 महीनेअवधि 6Chapters29टॉपिक

अभी पूछताछ करें

सिलेबस · पाठ्यक्रम

Download PDF

01Semiconductor Diodes 5 टॉपिक

Intrinsic and extrinsic semiconductors
PN junction and its V-I characteristics
Zener diode
LED, photodiode and varactor diode
Diode ratings

02Rectifiers and Filters 5 टॉपिक

Half-wave rectifier
Centre-tap full-wave rectifier
Bridge rectifier
Ripple factor and efficiency
Capacitor, inductor and pi filters

03Bipolar Junction Transistors 6 टॉपिक

Construction and working of NPN and PNP
CB, CE and CC configurations
Input and output characteristics
Alpha and beta
Biasing and stabilisation
Transistor as a switch

04FET and MOSFET 4 टॉपिक

JFET construction and characteristics
Shockley's equation
Enhancement and depletion MOSFET
Comparison of BJT and FET

05Amplifiers and Oscillators 4 टॉपिक

RC coupled amplifier and frequency response
Positive and negative feedback
Barkhausen criterion
RC phase shift, Hartley, Colpitts and crystal oscillators

06Regulated Power Supplies 5 टॉपिक

Need for regulation
Zener shunt regulator
Series transistor regulator
IC regulators 78xx and 79xx
SMPS (introduction)

परिचय

आप यह कर पाएँगे

Explain the PN junction and the characteristics of diodes, zener diodes and LEDs
Analyse half-wave, full-wave and bridge rectifiers with filters
Explain BJT configurations, characteristics and biasing
Explain JFET and MOSFET operation and characteristics
Explain amplifiers, feedback and oscillator circuits
Design simple zener and IC regulated power supplies

यह किसके लिए है

Diploma Electrical Engineering students of Semester 3 (BTEUP)
Diploma Electronics Engineering students of Semester 3 (BTEUP)
Students preparing for JE (Electrical / Electronics) exams

आपको क्या चाहिए

Basic electricity and physics of semiconductors from the first year

सवाल

Is this course for both Electrical and Electronics branches?

Yes. It is taught in Semester 3 of both branches as per the BTEUP scheme.

Will I see circuits working?

Circuits are explained with simulations and lab demonstrations where available.

Is this course based on the BTEUP syllabus?

Yes. The units follow the BTEUP (Board of Technical Education, Uttar Pradesh) diploma syllabus. If your polytechnic follows a different board or a revised scheme, the centre teaches your own syllabus.